Posted: Sun Oct 02, 2005 11:30 pm Post subject: Help, moving over from DouX2
Hi I'm moving over from the DuoX2 mod chip. In the Duo install I didn't need the LFRAME pin and the one next to it on the LPC. Do I need these for the Sunday chip?
(Just a side note, I like how straight forward this install instruction is. Good pic speaks a thousand word that even a 10mb guide can't beat.)
Any help would be great. As it is now, I just get the flubber and then a warning that my xbox needs servicing.
Sunday Xbox-HQ Member
Xbox Version: 1.0, 1.6 Modded: Sunday Chip w/IR Remote
Joined: May 29, 2005 Posts: 95
Posted: Mon Oct 03, 2005 12:50 pm Post subject:
Basicly Lframe is emulated by the CPLD so that one may be optional, although I dont see it saving much work in any case. Lrst is another pin next to Lframe and the SST flashron uses this since Sunday chip is a native LPC 3.3v solution. The doux is a parallel solution at 5v on the 3.3v LPC and does not use LRST. Again I don't see this saving any work unless it's a filled LPC hole 1.0. Just like Sunday doesn't need 5v unless you are doing an IR install on a 1.6 (marked B in the diagram you referenced).
So the top LPC hole above Lframe you need but I just solder all pins except the key no matter what install I'm doing anyway and so should you. If you are doing a wire install use 30AWG kynar from radio shack part number 276-508.
|
All times are GMT |Page 1 of 1
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum